Reading Techniques; Button And Led Indicator Location; Menu Bar Code Security Settings; Setting Custom Defaults - Honeywell Youjie YJ-HF600 User Manual

Reading Techniques

Present the bar code to the scanner. The LEDs turn up to read the code.

Button and LED Indicator Location

Menu Bar Code Security Settings

Honeywell scanners are programmed by scanning menu bar codes or by sending serial commands to the scanner. If you want
to restrict the ability to scan menu codes, you can use the Menu Bar Code Security settings. Please contact the nearest techni-
cal support office (see Customer Support

Setting Custom Defaults

You have the ability to create a set of menu commands as your own, custom defaults. To do so, scan the Set Custom Defaults
bar code below before scannning the menu commands for your custom defaults. If a menu command requires scanning
numeric codes from the back cover, then a Save code, that entire sequence will be saved to your custom defaults. When you
have entered all the commands you want to save for your custom defaults, scan the Save Custom Defaults bar code.
Set Custom Defaults
You may have a series of custom settings and want to correct a single setting. To do so, just scan the new setting to overwrite
the old one. For example, if you had previously saved the setting for Beeper Volume at Low to your custom defaults, and decide
you want the beeper volume set to High, just scan the Set Custom Defaults bar code, then scan the Beeper Volume High
menu code, and then Save Custom Defaults. The rest of the custom defaults will remain, but the beeper volume setting will be
updated.

Resetting the Custom Defaults

If you want the custom default settings restored to your scanner, scan the Activate Custom Defaults bar code below. This is
the recommended default bar code for most users. It resets the scanner to the custom default settings. If there are no custom
defaults, it will reset the scanner to the factory default settings. Any settings that have not been specified through the custom
defaults will be defaulted to the factory default settings.
Button/Green
LED
Right Blue LED
Right Blue LED Good Read
Left Blue LED Error
Button
Button / Green
Green
LED
LED
on page 1) for further information.
Activate Custom Defaults
Left Blue
See Serial Trigger Mode
Mobile Phone Read Mode activated
Save Custom Defaults
1 - 3