Xconnect Vsi - H3C MSR 5600 Comware 7 Vxlan Command Reference

Views
System view
Predefined user roles
network-admin
Parameters
port-number : Specifies a UDP port number in the range of 1 to 65535. As a best practice, specify
a port number in the range of 1024 to 65535 to avoid conflict with well-known ports.
Usage guidelines
You must configure the same destination UDP port number on all VTEPs in a VXLAN.
Examples
# Set the destination UDP port number to 6666 for VXLAN packets.
<Sysname> system-view
[Sysname] vxlan udp-port 6666

xconnect vsi

Use xconnect vsi to map an AC to a VSI.
Use undo xconnect vsi to restore the default.
Syntax
xconnect vsi vsi-name [ track track-entry-number&<1-3> ]
undo xconnect vsi
Default
An AC is not mapped to any VSI.
Views
Interface view
Predefined user roles
network-admin
Parameters
vsi-name : Specifies the VSI name, a case-sensitive string of 1 to 31 characters.
track track-entry-number&<1-3> : Specifies a space-separated list of up to three track
entry numbers in the range of 1 to 1024. The AC is up only if a minimum of one associated track entry
is in positive state.
Usage guidelines
For traffic that matches a Layer 3 interface, the system uses the VSI's MAC address table to make a
forwarding decision.
The access mode determines how a VTEP processes the 802.1Q VLAN tags in the inner Ethernet
frames assigned to the VSI.
•
VLAN access mode—Ethernet frames received from or sent to the local site must contain
802.1Q VLAN tags.
For an Ethernet frame received from the local site, the VTEP removes all its 802.1Q VLAN
tags before forwarding the frame.
25