Port Id Display - ATEN CM1284 User Manual

Multi-View KVMP™ Switch User Manual

Port ID Display

The Port ID Display command allows you to configure the port ID for each
port. Type your command in the following format:
Command + Control + [Enter]
Command
portid
Control
pxyy
default
For example, to set all port ID's to the factory default, type the following:
portid default [Enter]
For example, to change port 4's ID number to Computer_A, type the
following:
portid pComputer_A [Enter]
Note: 1. Each command string can be separated with a space.
2. To avoid RS-232 command loss, it is recommended to enter every
RS-232 command with a two-second gap.
88
Port ID Display Command
Change the port ID number.
x= 1~4 (Current Port ID)
yy = A ~ Z, a ~ z, 0 ~ 9, dash, underscore, maximum 20
characters (New Port ID)
Reset all port IDs to the factory default.
Description
Description