Table of Contents
Advertisement
Multi-View KVMP™ Switch User Manual
4. Configure and adjust the display as required. You can do the following
when the editor mode is enabled:
Function
Change the display mode
Apply a preset configuration Click an Fn icon from the Quick Access Toolbar. For
Swap locations of video
sources in quad mode
Resize windows
Relocate windows
Set windows to the front or
the back
Reset
Note: When the editor mode is enabled, the OSD Menu will not be
accessible and the hotkeys functionality will be disabled.
5. When you finish configuring, click
58
Click a display mode from the Quick Access
Toolbar.
Click
to display the window in full screen.
more information, see Preset Configuration,
page 45.
Click the port number at the top left corner and
select a port.
Note: Under 4K resolution, to use this function in a
Quad view, make sure port 1 and 2, port 3 and 4 are
next to each other.
Click on a window, move the cursor to a corner of
the window, and drag the corner to resize the
window.
Note: Under 4K resolution, red zones appear to
indicate the resized window exceeds the restricted
limits.
Click and hold on a window to drag it to a desired
location on the screen.
Note: Under 4K resolution, red zones appear to
indicate restricted areas for the dragged window.
When two windows overlap, you can configure
which one appears on top of the other. To bring a
window on top of the other, click the window, and
then click
. Click
window to the back.
Click
to reset all the port location and size back
to default settings.
to quit the editor mode.
Action
to send the selected
Advertisement
Table of Contents
