Multi-View KVMP™ Switch User Manual
PoP Mode
The PoP Mode command allows you to change the Picture on Picture display
mode settings. Type your command in the following format:
Picture on Picture Mode Setting:
Command + Control1 + Control2 + Control3 + Control4 + [Enter]
Picture on Picture default Mode Setting:
Command + Control1 + [Enter]
Command
pop
Control
cxpy
default
For example, to set Picture on Picture Mode, you must configure the four
channels, and type the following:
pop c1p1 c2p2 c3p3 c4p4 [Enter]
For example, to set Picture on Picture Mode to the default settings, type the
following:
pop default [Enter]
Note: 1. Each command string can be separated with a space.
2. The Port Number command string can be skipped, and the default
value will be used.
3. To avoid RS-232 command loss, it is recommended to enter every
RS-232 command with a two-second gap.
80
Picture on Picture Mode
c: Output channel, x= 1~4
p: Input port, y= 1~4
Example: c2p4
Resets Picture on Picture Mode back to the default setting
Example: c1p1~c4p4
Description
Description