Hardware Cursor - ATEN CM1284 User Manual

Hardware Cursor

The Hardware Cursor command allows you to enable/disable the hardware
cursor feature. Type your command in the following format:
Command + Control + [Enter]
Command
hc
Control
off
on
For example, to enable the hardware cursor, type the following:
hc on [Enter]
Note: 1. Each command string can be separated with a space.
2. To avoid RS-232 command loss, it is recommended to enter every
RS-232 command with a two-second gap.
Hardware Cursor Command
Disable the hardware cursor
Enable the hardware cursor
Chapter 6. RS-232 Operation
Description
Description
95