ATEN CM1284 User Manual page 62

Multi-View KVMP™ Switch User Manual
Hotkey
Display [A] [[n]] [Enter]
Settings
[J] [n] [Enter]
[P] [n] [Enter]
50
Start Auto Scan with which the KVM focus cycles from
port to port at at the specified interval (n = 5, 10, 15, 30,
60, 90 seconds). The default interval is 5 seconds.
See Auto Scanning, page 53 for more information.
Set the video content for Monitor 2. This function is only
supported on the CM1284. [n] specifies the source of
the displayed video.

n is omitted (Displays the content of the focused
window on Monitor 1)

n = 1 (Always displays the video from port 1)

n = 2 (Always displays the video from port 2)

n = 3 (Always displays the video from port 3)

n = 4 (Always displays the video from port 4)
Switch to the specified (n) display mode. For more
information on display modes, See Display Modes,
page 35.

n = 0 (PoP)

n = 1 (Quad view)

n = 2 (PiP dual view)

n = 3 (PiP triple view)

n = 4 (PiP quad view)

n = 5 (PbP dual view)

n = 6 (PbP triple view)

n = 7 (PbP quad view)
Function