Pbp Mode - ATEN CM1284 User Manual

PbP Mode

The PbP Mode command allows you to change the Picture by Picture display
mode settings. Type your command in the following format:
Picture by Picture Dual Mode Setting:
Command + Control1 + Control2 + [Enter]
Picture in Picture Triple Mode Setting:
Command + Control1 + Control2 + Control3 + [Enter]
Picture in Picture Quad Mode Setting:
Command + Control1 + Control2 + Control3 + Control4 + [Enter]
Command
pbp1
pbp2
pbp3
Control
cxpy
For example, to set Picture by Picture Dual Mode, you must configure the four
channels, and type the following:
pbp1 c1p1 c2p2 [Enter]
For example, to set Picture by Picture Triple Mode, you must configure the
four channels, and type the following:
pbp2 c1p1 c2p2 c3p3 [Enter]
For example, to set Picture by Picture Quad Mode, you must configure the four
channels, and type the following:
pbp3 c1p1 c2p2 c3p3 c4p4 [Enter]
Note: 1. Each command string can be separated with a space.
2. The Port Number command string can be skipped, and the default
value will be used.
3. To avoid RS-232 command loss, it is recommended to enter every
RS-232 command with a two-second gap.
Picture by Picture Dual Mode
Picture by Picture Triple Mode
Picture by Picture Quad Mode
c: Output channel, x= 1~4
p: Input port, y= 1~4
Example: c2p4
Chapter 6. RS-232 Operation
Description
Description
79