Table of Contents
Advertisement
IR Remote Control
No.
Component
1
OSD button
2
Fn1 / Fn2 / Fn3 /
Fn4 buttons and
select button
3
display mode
buttons
4
KVM port selection
buttons 1~4
2
3
4
5
Press this button to turn on or turn off the OSD Menu.
When the OSD Menu is enabled, press the OSD button to
go back to the previous menu / submenu.
Use these buttons to switch between Function modes (Fn1
to Fn4), and to cycle through the OSD Menu/selection.
See Preset Configuration, page 45 for details on how to
store function mode settings, which you can invoke for later
use.
The Fn1~Fn4 buttons are positioned to correspond to the
up / down / left / right direction.
When cycling through the menu options, press the Select
button to go the submenu.
If you want to change or adjust a selection/value, press
the Select button then the Fn1 (up) / Fn2 (left) / Fn3
(down) / Fn4 (right) buttons to go through all the
selections/values. Press the Select button again to
confirm a selection.
Select the display mode you want to view. See Display
Modes, page 35.
Press these buttons to switch ports (1~4).
In a cascade setup, press these buttons to switch the
console display to the corresponding secondary
TM
KVMP
Description
Switch.
Chapter 1. Introduction
1
11
Advertisement
Table of Contents
