Table of Contents
Advertisement
Multi-View KVMP™ Switch User Manual
Open/Close RS-232 Link
The Open/Close RS-232 Link command allows you to open/close the link
between the computer sending RS-232 commands and the Multi-View
KVMP™ Switch. When the link is "open" the Multi-View KVMP™ Switch
only accepts RS-232 commands and will not respond to front-panel
pushbuttons, hotkeys, OSD, or remote control signals - until the link is closed.
The link opens when you log in and closes after 2 minutes if no command is
sent. Type your command in the following format:
Command + [Enter]
Command
open
close
For example, to open the RS-232 Link between the computer and Multi-View
KVMP™ Switch, type the following:
open [Enter]
For example, to close the RS-232 Link between the computer and Multi-View
KVMP™ Switch, type the following:
close [Enter]
Note: To avoid RS-232 command loss, it is recommended to enter every RS-
232 command with a two-second gap.
72
Open RS-232 Link Command
Close RS-232 Link Command
Description
Advertisement
Table of Contents
