ATEN CM1284 User Manual page 74

Multi-View KVMP™ Switch User Manual
Setting
HSM
Menu Hotkey
Display
Channel Info
Multiview Mode
Channel 1
Channel 2
Channel 3
Channel 4
Save to Fn
Toolbar Position
Transparency
Window Frame
Port Configuration
62
Options
[Num][-] / [Ctrl][F12]
Scroll*2 / Ctrl*2
Enable / Disable
Single / Quad / PiP2 /
PiP3 / PiP4 / PoP /
PbP1 / PbP2 / PbP3 /
Fn1 / Fn2 / Fn3 / Fn4
Port 1 / Port 2 / Port 3 /
Port 4
Port 1 / Port 2 / Port 3 /
Port 4
Port 1 / Port 2 / Port 3 /
Port 4
Port 1 / Port 2 / Port 3 /
Port 4
Fn1 / Fn2 / Fn3 / Fn4
Top / Bottom
Enable / Disable
Disable / 3 secs / 5
secs / 10 secs / always
on
Description
Defines the hotkey combination for
enabling the Hotkey Setting Mode
(HSM).
Sets the hotkey combination for
opening the menu.
Enable this setting to display port ID
numbers and device names.
Sets or changes the display mode for
the Multi-View KVMP™ Switch. For
details about each display mode, see
Display Modes, page 35.
Sets the source assignment for each
channel. For example, if you select
Port 2 for Channel 1, port 2 source will
be displayed on Channel 1, and port 1
source will be displayed at Channel 2.
Saves the view mode settings to the
selected Function mode.
Sets the position of the Quick Access
Toolbar.
Enable this setting to make the inset
window(s) of a PiP display semi-
transparent.
Note: This setting only applies to the
built-in PiP2, PiP3, and PiP4 modes.
Sets the duration for Window Frame.
Note: Hardware Cursor Mode must be
enabled, see The OSD Menu, page 59.