Figure 6-5 Reset Switch (Behind The Front Panel) And Front Panel Status Leds - Sun Microsystems SPARCserver 1000 Service Manual

Reset switch
Status LEDs
Figure 6-5
3. After the system is reset, replace the front plastic panel.
Rest the top of the front panel in the grooved channel on the top panel. Push
in on the lower portion of the front panel until it snaps back into place.
4. Return the key to the key switch.
Warning – Once the system is started, do not move or attempt to move the
!
chassis with system power on. Failure to heed this caution may result in
catastrophic disk drive failure. Always power the system off completely before
attempting a move.
Powering Off and On
Reset Switch (Behind the Front Panel) and Front Panel Status LEDs
6
6-7