Sun Microsystems Enterprise Tape Library 7/3500 Field Service Manual page 228

TABLE B-1
Sense
Key
4
4
4
4
B
4
4
198 Sun Enterprise Tape Library 7/3500 Field Service Manual • July 1997
Sense Data Values (Hexadecimal) (Continued)
ASC ASCQ Message Name/Description
8D 06 DLT DRIVE HANDLE MOTOR CURRENT
FEEDBACK TEST FAILURE
Unable to sense current feedback from
stepper motor controller during self-test.
Check motor cable connections.
8E 01 FLASH MEMORY UNABLE TO IDENTIFY
Flash is soldered onto the board. Replace the
robotic controller.
8E 02 FLASH MEMORY UNABLE TO ERASE
Flash is soldered onto the board. Replace the
robotic controller.
8E 03 FLASH MEMORY UNABLE TO PROGRAM
Flash is soldered onto the board. Replace the
robotic controller.
8F 00 LIBRARY UNIT COMMAND TIMED OUT
Verify that communications to library still
exists by issuing another command
F3 02 DLT DRIVE COMMUNICATION TIMEOUT
The library is unable to communicate with a
drive.
F3 11 DLT DRIVE HANDLE NOT OK
The tape drive is reporting that the handle
cannot open. (This may indicate that a DLT
cartridge is present that has not been
unloaded.)
Interface
Both
Diag
Diag
Diag
SCSI
Both
Both