Cabletron Systems Netlink FRX8000 Installation And Setup Manual page 91

Enterasys netlink frx8000 interface module: install guide
Hide thumbs Also See for Netlink FRX8000:
Table of Contents

Advertisement

Underruns
Token Ring-Specific Statistics
FCS Violations
Copy Errors
Trans Absences
Frequency Errors
Frm with Aborts
Act Mon Regen
No Return Frms
Underruns
No Buff Avail
A/C Errors
Local Node Displays
is the number of frames that were not accepted due to DMA
(direct memory access) under run errors.
is the number of frames received that have failed the Frame
Check Sequence (FCS) cyclic redundancy check (CRC).
is the number of frames received with duplicate addresses.
is the number of five half-bit time transitions. The counter is
incremented every time transitions are not detected between
SDEL and EDEL in a repeated frame.
is the number of frames received with signal frequency
problems.
is the number of frames that were aborted in mid transmission.
is the number of times the active monitor is lost and regen-
erated.
is the number of frames that fail to return from around the ring
due to a timeout or reception of another frame.
is the number of frames that were not accepted due to DMA
(direct memory access) under run errors.
is the number of frames that could not be received/repeated
due to lack of buffer space.
is the number of AMP and SMP MAC frames with AC (ARI/
FCI) equal to zero when an intervening AMP MAC frame was
not received.
3- 31

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Netlink FRX8000 and is the answer not in the manual?

Questions and answers

Table of Contents