Lp Configuration Menu - Cabletron Systems Netlink FRX8000 Installation And Setup Manual

Nod e ID
LP ID
LP Type
A C ard A
B C ard B
R Port Con figu ration
Select:
Press
[A]
figure both, if necessary, to make the record match the actual cards.)
15. When finished configuring the Line Interface Cards, press
Figure 2-20.
16. When prompted, enter:
Port:
Underlying Physical Port (only if the port number is
Physical Port Type (if asked):
17. The displayed menu depends on whether the port is a physical trunk
(Figure 2-21) or logical trunk
When this node is connected to the operational network, the values specified
in the local node configuration must match the database values. The param-
eters to be configured are described under "Configuring Inter-Nodal Trunks"
in the Netlink FRX8000 User Guide.
18. To change a value in a Port Configuration record, press the letter that precedes
the parameter. Values of
opposite. Other values must be entered.
Installing a Node
LP Con figu ration Men u
Figure 2-20 LP Configuration Menu
or if necessary and specify the correct Line Interface Card. (Con-
[B]
. ( are physical ports;
0–63 0–7
(Figure
or
Y N
10
1
7
4 High-sp eed RS -232
4 High-sp eed RS -232
are logical ports.)
8–63
(X.25) or (Frame Relay).
X F
2-22).
(yes or no) will automatically change to the
at the screen in
[R]
): .
8–63 0-7
2- 29