Cabletron Systems Netlink FRX8000 Installation And Setup Manual page 41

26. Press
[Enter]
27. When prompted to
taneously)
28. When the date and time are displayed, press
29. When asked:
30. At the
scosysv!login:
31. When asked for a password, type
32. At the
[NETLINK]
33. Check the printer messages to assure that everything started correctly. After it
starts, the node's screen will display the FRX8000 Test Menu
The remainder of this procedure is performed at an INM in the opera-
tional network.
34. At an INM in the operational network, press
Main Menu to display a menu of Boot Disk Download Operations.
35. Press
[A]
36. When prompted, enter the ID of the new node.
37. When a message informs you that the operation is complete, press any key.
This will display the Boot Disk Download Operations Menu.
38. Press . This will display the Node Operations Menu.
[R]
39. Press
[B]
Installation of the ICP is now complete, and the node is operational (once it com-
pletes the re-IPL and displays the FRX8000 Test Menu).
Archiving and Restoring the Database
The archive part (steps 1–8) of this procedure are performed at an INM
in the operational network. The restore part (steps 9–35) are done at the
new ICP.
1. You will need one or two (depending on the size of the database) 3½-inch
1.44MB diskette(s), formatted for UNIX. To format a diskette, insert it into the
drive in the INM and type
2. Press
[R]
[NETLINK]
3. Insert a formatted diskette into the drive and type
an NMP Utilities Menu.
Installing a Node
at the prompt.
Boot
Type Control-D to proceed with normal startup
.
[Ctrl] [D]
Check protected subsystem database?
prompt, type
prompt, type
start -icp [Enter]
to select
Configuration Update
to re-IPL the new node. When prompted, enter the node ID.
format [Enter]
at the INM's Main Menu to exit the menu level and display the
prompt.
.
[Enter]
, type
.
netlink [Enter]
.
mypass [Enter]
.
, then
[B] [B]
.
.
util [Enter]
, press (simul-
.
y [Enter]
(Figure 2-12).
, then from the
[D]
. This will display
2- 23