Cabletron Systems Netlink FRX8000 Installation And Setup Manual page 54

22. At the UNIX login prompt, type
23. When asked for a password, type
24. At the # prompt, type
off.)
25. After about a minute, you will be prompted:
to continue with the shutdown process.
y [Enter]
26. Messages will be displayed, ending with:
** Safe to Power Off **
**Press any key to Reboot**
Switch the unit off.
27. Connect all trunk cables from the new node to other nodes in the network.
28. Switch the INM on.
29. Press
[Enter]
30. When prompted to
taneously)
31. When the date and time are displayed, press
32. When asked:
33. At the
scosysv!login:
34. When asked for a password, type
35. At the
[NETLINK]
the FRX8000 Test Menu
This completes installation of the INM. If the device has a LAN card installed, go
to "Configuring
To access the INM menus:
1. Press
[Alt] [F3]
2. At the
scosysv!login:
3. When asked for a password, type
4. At the
[NETLINK]
2-36
root [Enter]
sync; shutdown -g0 [Enter]
- or -
at the prompt.
Boot
Type Control-D to proceed with normal startup
.
[Ctrl] [D]
Check protected subsystem database?
prompt, type
prompt, type
start -icp [Enter]
(Figure
TCP/IP" on page 2-37.
at the FRX8000 Test Menu.
prompt, type
prompt, type
gcon [Enter]
.
.
mypass [Enter]
. (Ignore any warnings to log
Do you want to continue?
.
[Enter]
, type
.
netlink [Enter]
.
mypass [Enter]
. When the INM is operational,
2-12) will be displayed.
.
netlink [Enter]
.
mypass [Enter]
.
FRX8000 Installation & Setup Guide
Type
, press (simul-
.
y [Enter]