Cabletron Systems Netlink FRX8000 Installation And Setup Manual page 43

For the remainder of this procedure, the words "and press" will be
omitted if you are asked to type information and press
example, "type
14.
scosysv!login:
15. When asked for a password, type
16. At the
[NETLINK]
Menu.
17. Type
8 [Enter]
18. When prompted, insert the first/only archived diskette into the drive and press
. The database will be copied from the diskette, overwriting the
[Enter]
database in the new ICP. If the archived database is on more than one disk,
insert each one, in order (when prompted), and press
no more diskettes to restore, remove the current one from the drive and press
. You will be returned to the NMP Utilities Menu.
[Enter]
19. The node number will be the node at which the database was archived, so you
must now change it to the number of the new node. Type
prompted, type the new number (
20. Type
9 [Enter]
21. Type logout
22. At the UNIX login prompt, type
23. When asked for a password, type
24. At the # prompt, type
off.)
25. After about a minute, you will be prompted:
to continue with the shutdown process.
y [Enter]
26. Messages will be displayed, ending with:
** Safe to Power Off **
**Press any key to Reboot**
Switch the unit off.
27. Connect all trunk cables from the new node to other nodes in the network.
28. Switch the ICP on.
29. Press
[Enter]
30. When prompted to
taneously)
31. When the date and time are displayed, press
Installing a Node
and press
y
will be displayed. Type
prompt, type
util [Enter]
( ).
Restore Database
to exit to the
[NETLINK]
.
[Enter]
root [Enter]
sync; shutdown -g0 [Enter]
- or -
at the prompt.
Boot
Type Control-D to proceed with normal startup
.
[Ctrl] [D]
" will be written "type
[Enter]
.
netlink [Enter]
.
mypass [Enter]
. This will display an NMP Utilities
[Enter]
) and press
1–250 [Enter]
prompt.
.
.
mypass [Enter]
. (Ignore any warnings to log
Do you want to continue?
.
[Enter]
. For
[Enter]
."
y [Enter]
. If/when there are
and, when
1 [Enter]
.
Type
, press (simul-
2- 25