Virtual Connections Display; Virtual Connections Display On Frame Relay Port - Cabletron Systems Netlink FRX8000 Installation And Setup Manual

Virtual Connections Display

To display all physical and logical connections on a physical port, press
Status Display Menu and, when prompted, enter the LP and physical port numbers.
The display will differ depending on whether or not the port is a Frame Relay port,
as shown in Figure 3-4 and Figure 3-5.
FRX8000 Con nection Status D is play Men u (Page 1)
From:
Seq DLC I State
1 16 Data_trans
2 17 Data_trans
3 18 Data_trans
4 20 Data_trans
5 32 Data_trans
6 33 Data_trans
7 34 Data_trans
8 35 Data_trans
9 36 Data_trans
10 25 Data_trans
11 24 Data_trans
12 42 Data_trans
13 43 Data_trans
14 44 Data_trans
Figure 3-4 Virtual Connections Display on Frame Relay Port
Information in this Display
is a sequence number used to identify the connection.
Seq
is the DLCI on which the connection exists.
DLCI
:
State Data_trans
Call_setup
Clearing
Resetting
Port_down
Local Node Displays
Node: 10 LP: 0 Port: 0
To:
Trans Recd D is c N LP P
587 497 0 10 0 9
588 574 0 10 0 10
592 586 1 10 0 11
580 486 0 10 0 14
585 602 6 10 0 18
600 594 0 10 0 19
621 600 0 10 0 22
579 543 0 10 0 23
586 584 0 10 0 24
588 586 4 10 0 30
593 610 0 10 0 29
602 498 5 10 0 33
610 506 0 10 0 34
585 568 0 10 0 35
[A],[C]
means that call processing was successful and the connection
is in the data transmission state.
means that the attached device is waiting for a Call Accept.
means that the attached device is in Call Clear state, waiting
for a Clear Confirmation.
means that a Reset has been sent to the remote device, and the
attached device is waiting for a Reset Confirmation.
is self-explanatory.
DLCI S tate
16 D ata_trans
17 D ata_trans
18 D ata_trans
20 D ata_trans
28 D ata_tran s
29 D ata_trans
30 D ata_trans
31 D ata_trans
32 D ata_trans
25 D ata_trans
24 D ata_trans
42 D ata_trans
43 D ata_trans
44 D ata_trans
from FRX8000 Test Menu
at the
[C]
3- 5