X.25 Logical Trunk, Level 3 Parameters - Cabletron Systems Netlink FRX8000 Installation And Setup Manual

X.25 Trun k Configuration Menu (Level 3 Info)
Nod e ID
LP I D
Port
X25 Physical Port
A Low es t Tw o-way C hann el
B Highest Two-way Chan nel
C Flow Control Negotiation
D Th ru put Class Negotiation
E Maximum Packet S ize
F D efau lt Max Pack et Size
G Maximum Win dow Size
H D efau lt Window Size
I Maximum Throughp ut C las s
J R es tart Timer (s ec)
K I nc. Call Timer (s ec)
L R es et Timer (s ec)
M C lear Timer (sec)
P Logical Trunk Parameters
Q Previous S creen
R R etu rn to Main Men u
Select:
Figure 2-24 X.25 Logical Trunk, Level 3 Parameters
19. When the port is configured the way you want it, press
uration Menu
then again at the Integrated Network Manager Configuration Menu
(Figure 2-19).
20. At the prompt, type
#
off).
21. After about a minute, you will be asked:
to continue with the shutdown.
[Enter]
22. Messages will be displayed, ending with:
** Safe to Power Off **
**Press any key to reboot**
23. Switch the device off.
24. Connect all trunk cables from the new node to other nodes in the network.
25. Switch the INM on.
26. Press
[Enter]
2-32
10
0
8
2
10
4095
N
N
4096
4096
7
7
10
60
180
60
60
Pressing at the screen in Figure 2-24 will display a screen of
[P]
logical parameters.
(Figure 2-21 [physical trunk] or
sync; shutdown -g0 [Enter]
- or -
at the prompt.
Boot
at the Port Config-
[R]
Figure 2-22 [logical trunk]),
. (Ignore any warnings to log
Do you want to continue?
FRX8000 Installation & Setup Guide
Type
y