Statements Of Compliance; United States (Fcc) - Cabletron Systems Netlink FRX8000 Installation And Setup Manual

Enterasys netlink frx8000 interface module: install guide
Hide thumbs Also See for Netlink FRX8000:
Table of Contents

Advertisement

Notice
Cabletron Systems reserves the right to make changes in specifications and other information con-
tained in this document without prior notice. The reader should in all cases consult Cabletron
Systems to determine whether any such changes have been made.
The hardware, firmware, and/or software described in this manual is subject to change without
notice.
IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL,
INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING
BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS
MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS
HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF
SUCH DAMAGES.
Copyright 1997, 1998 by Cabletron Systems, Inc. All rights reserved. Printed in the United States of
America.
Also see third-party software copyrights in the Netlink FRX8000 User Guide.
Netlink is a trademark of Cabletron Systems, Inc. All other product designations are the property of
their respective owners.

Statements of Compliance

United States (FCC)

The equipment provided by Cabletron Systems, Inc. and documented in this manual has been tested
and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the installation manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to, at his/her own expense, take the necessary measures to elim-
inate the interference.
To ensure compliance with the Class A FCC limits, use only shielded cables with this equipment.
Any cable installed above a ceiling or below a floor must be of a material and construction approved
by UL for that application.
ii
FRX8000 Installation & Setup Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Netlink FRX8000 and is the answer not in the manual?

Questions and answers

Table of Contents