Setting The Station And Fnb Ip Addresses; Setting The Subnet Mask - Cabletron Systems TRBMIM User Manual

DEVICE SETUP MENU

4.1.2 Setting The Station And FNB IP Addresses

The TRBMIM/TRBMIM-T has an IP Auto-Configuration feature
NOTE
that automatically attempts to get an IP address from a BootP
server on the network at power up when the
TRBMIM/TRBMIM-T does not have an IP address. See the
TRBMIM-T User's Guide for more information about the IP
Auto-Configuration feature.
Use the
IP Address
TRBMIM/TRBMIM-T Station port and the FNB port.
To set the IP address:
1. Select the
IP Address
2. Type the IP Address into the field. The correct format for this entry is
xxx.xxx.xxx.xxx
If the format is invalid, the "
message appears. Retype the address using the correct format.
3. Press the Enter key.
The new value appears in the
operation, the corresponding
mask for the class (A, B, or C) of the IP address entered in the
field.
Address
4. Repeat Steps 1 through 3 to set the address for the other port.
5. Select
SAVE
The "
SAVED OK

4.1.3 Setting The Subnet Mask

Subnets are logical divisions of the network that serve to isolate groups of
devices. The
Subnet Mask
TRBMIM/TRBMIM-T directs SNMP Trap messages to a destination
address. (See Section 4.3 for information about SNMP Traps.)
The TRBMIM/TRBMIM-T directly addresses destinations within its own
subnet and sends messages destined for other subnets to a router. Use
these guidelines to determine the
4-4
field to set the Internet Protocol (IP) address for the
field for the port you want.
, with values of
, and then press the Enter key.
" message appears.
setting determines how the
ranging from
xxx
INVALID IP FORMAT ENTERED
field. In response to the
IP Address
Subnet Mask
Subnet Mask
000-255
field assumes the default
field setting:
.
"
IP