Table of Contents
Advertisement
INSTALLATION/CONFIGURATION
This chapter contains instructions for:
• unpacking the TPXMIM
• installing the TPXMIM into a Multi Media Access Center (MMAC)
• configuring the TPXMIM board or individual ports to run on
MMAC backplane Channels
• adding/replacing optional Ethernet Port Interface Modules
• connecting your device to a network.
3.1 UNPACKING THE TPXMIM
Unpack the TPXMIM as follows:
1. Remove the shipping material covering the TPXMIM.
2. Carefully remove the module from the shipping box. Leave the
module in its non-conductive bag until you are ready to install it.
3. Visually inspect the module. If you notice any signs of damage,
contact Cabletron Systems Technical Support immediately.
3.2 INSTALLING THE TPXMIM
Installing the TPXMIM into any MMAC hub is an easy operation and
requires no special skills or tools. However, when you install your device,
keep the following in mind:
• You may install the TPXMIM in any slot except for slot 1 (farthest
slot to the right) of the MMAC chassis.
TPXMIM Installation Guide
CHAPTER 3
Page 19
Advertisement
Chapters
Table of Contents
Troubleshooting
