Connecting To A Vt Series Terminal - Enterasys Matrix E1 Series Installation Manual

Connecting to Console Port for Local Management
4. Turn on the PC and configure your VT emulation package with the following parameters:
When these parameters are set, the Startup screen will display. Proceed to
the installation.
Figure 3-21 Connecting an IBM PC or Compatible
Ã
➀
straight-through
UTP
➁
RJ45 console port
3.9.3

Connecting to a VT Series Terminal

To connect a VT Series terminal to an Enterasys Networks device Console port
a UTP cable with RJ45 connectors and an optional RJ45-to-DB25 female adapter (PN 9372110),
and proceed as follows:
1. Connect the RJ45 connector at one end of the cable ➀ to the Console port ➁ on the Enterasys
Networks device.
3-30 Hardware Installation
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Â
cable with RJ45 connectors
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
1G582-09
RESET
À
➂
RJ45-to-DB9 PC adapter
➃
PC
Section 3.10 to complete
PWR
CPU
COM
1 1
Á
(Figure 3-22), use