Exchange Of Transport Timing Belts; Exchange Of Rollers - Weber Geset 100 Original User Manual

Chapter 9 Maintenance

Exchange of transport timing belts

If the transport timing belt is damaged or worn, it has to be replaced. Observe that the
new transport timing belt is also suitable for the base conveyor and that it has the spe-
cified dimensions. When using own timing belts, changes in the conveying behavior may
occur. We recommend to use only our original transport timing belts.
Requirements
Labeling station is without power.
¥
No transportation of products.
¥
Instruction
Please exchange the base conveyor as follows.
Step
1
2
3
4
5
6

Exchange of rollers

The lifetime of drive rollers in the bearings depend on the appropriate load and the
conveyor speed.
They are normally sufficient for an operational time of 4-5 years. After this time it is advi-
sable to exchange the bearing or rollers.
Version: 16.07.13
Procedure
Dismantle all assembly parts (side guidings, hopper aso.), that may impact
the belt change.
Dismantle the deflection plate with deflection roller that is located opposite to
the roll of the drive timing belt.
Put out the timing belt laterally. Put in a new timing belt in revised order.
Mount deflection plate with deflection roller.
Reinstall if available the assembly parts again.
Tension the transport timing belt (see page 68).
Page 70 of 77
32708885 Geset 100
GB