Weber Geset 100 Original User Manual page 10

Chapter 1 General information
Term
HPU
Infeed
Label applicator
Label feed
Label gap
Label liner
Label Out
Label sensor
Label size
Labeling system
Labeling operation
Labeling system
LED
Low label prewarning:
Low Label warning
Opacity
PLC
Poti/potentiometer
Pressure Gauge
Pressure rollers
Product Detector
Version: 16.07.13
Explanation
The abbreviation of Height Processing Unit: A device that is
driven by a motor or pneumatically to move a labeler verti-
cally. This feature enables different labeling positions in
vertical direction.
The products are fed manually or by a conveying system
provided by the customer at infeed passage of the labeling
station.
See "labeler".
Feeding of a label by the labeler. The fed label is printed on
within the print engine and peeled off at the peeler bar.
Distance between two labels at the label web. The gap is
detected by a (label) sensor of the applicator.
Siliconized liner material where single labels stick onto.
An optical sensor (reflective light sensor) for detecting the
end of the labels
An optical sensor that determines the gap between the la-
bels
Dictates the label format: Width x length (in the direction of
feed of the label liner measured in millimeters [mm]).
Dispensing system for automatically applying labels
This is the same as automatic mode. The labeling system is
ready to print and dispense labels
The labeling system is used to label products automatically
and consists of several components (assembly groups),
e.g. conveyor belt, labeling system.
Light-emitting diode
An optical sensor (reflective light sensor) for detection of an
(adjustable) minimum label roll diameter to provide a warn-
ing
The transparency of a material can be measured by a light
barrier and is named opacity. The measuring sets the quan-
tity of the radiated light in proportion to the incoming light.
The lower the proportion, the lower is the opacity.
Programmable logic controller.
Changeable resistor (controller) for the analog control of
labeling system settings (such as the timing of the tamp
movement in relation to the rotary position of the potenti-
ometer)
See service unit, displays the air pressure.
Pushes the label onto the product adhesively.
A sensor for detecting the product. Most frequently, optical
sensors are used (photocells, light barriers, reflective sen-
sors).
Page 10 of 77
32708885 Geset 100
GB