Weber Geset 100 Original User Manual page 51

Chapter 7 Adjustment and initial operation
Information on adjustment of gimbal
Fig. 7-13 shows the different adjustment possibilities (A and B) of the gimbal.
The inclination of the peeler plate (s. Fig. 7-13 lefthand figure) enables the correction of
the parallelism between label and product. Generally conveyor belt and peeler plate have
to be adjusted parallel to each other. Possible exceptions are products with curves or slo-
pes or wrap-around labeling with wrap belt or three-roll systems (only for experienced,
trained personnel). After adaption of the inclination, an increase of the feed speed of the
labeler may be necessary.
The figure on the righthand side shows the adjustment of the tamp pad for conical pro-
ducts. The tamp pad has to be adjusted parallel to the product shape.
Requirements
All points of „Change peeler plate" from page 47 (until step 5) are fullfilled.
¥
Required equipment
Tools
¥
Instruction
Please adjust inclination as follows
Step
1
2
3
4
Version: 16.07.13
Procedure
Loosen the counternuts (Fig. 7-12: Pos. 4) and the mounting screws (Fig.
7-12: Pos. 5).
Adjust the inclination with the setscrews (Fig. 7-12: Pos. 3) to the required
criteria (s. section above).
Tighten again screws and counternuts.
Chech this adjustment and correct it if necessary.
Page 51 of 77
Fig. 7-13: Inclination angle of peeler plate with gimbal
32708885 Geset 100
GB