Table of Contents
Advertisement
Chapter 9 Maintenance
Belt run correction of conveyor belts
No.
1
2
3
All rolls involved in belt running should be possibly parallel and exactly right-angled to
conveyor axis.
The correction of the belt run should take place at the rolls at which the chain runs from a
longer distance that is not influenced by any deflection.
Requirements
No transportation of products.
¥
Emergency stop pushbutton is unlocked.
¥
Labeling station is connected to power.
¥
Labeling station was put into operation (see chapter "Installation and initial
¥
startup").
Instruction
Please adjust the belt running direction as follows.
Step
1
2
3
4
Version: 16.07.13
Description
TRANSPORT DIRECTION
DIRECTION WHERE THE BASE CONVEYOR RUNS
ADJUSTMENT DIRECTION OF THE DEFLECTION ROLLER TO BELT RUN
CORRECTION
Procedure
Risk of injury! The examination of the belt running has to be arranged when
the labeling station is running under load.
- Do not grip in, at or between the moving parts.
Start base conveyor.
Tense slightly the deflection rollers at the side where the base conveyor runs
to.
Transport belts should run for a certain time.
Control belt running, correct it again if applicable.
Page 68 of 77
32708885 Geset 100
Fig. 9-1 Adjust base conveyor principle
GB
Advertisement
Table of Contents
