Weber Geset 100 Original User Manual page 54

Table of Contents

Advertisement

Chapter 7 Adjustment and initial operation
Information on adjustment of pusher roller, - brush and squeegees
The pusher is located so far behind the labeler, that even if it springs back, there will not
be any contact with the peeler plate. It can normally be adjusted by simple axis – and
clamping piece brackets (s. positioning device from page 36). It is possibly exactly ad-
justed in height of the sticked labels. The height of the pushing with which the pusher ope-
rates, can be adjusted by the blade angle and the distance to the conveyor belt's center
(ref. Fig. 7-15). Following rules apply:
The more flat the angle and the lower the distance, the larger the force.
¥
The force should be as small as possible but as large as necessary without the
¥
product being influenced in its further transportation.
At 2-side labeling, the alignment of the pusher has always to be symmetrical for a
¥
constant force distribution.
Observe when using squeegees that only the side with the rounded edges shows in direc-
tion to the product.
Pushers are powered by pushers that are often started by a pneumatic cylinder. Pushers
have to be extended completely for adjustment. Therefore they may be pulled out manual-
ly if they are without compressed air.
Requirements
The „Positioning of peeler plate to product" from page 48 is completely terminat-
¥
ed.
Labeling system is turned on and ready for operation.
¥
One or more sample products.
¥
No transportation of products.
¥
Instruction
Please adjust the pushers as follows:
Step
1
2
3
4
Version: 16.07.13
Procedure
Place one product at the infeed passage of the system.
Hazards from actively controlled movements.
Maintain a distance from moving parts.
Start briefly the base conveyor and stop it when the product is in the area of
the pusher.
Adjust the distance and angle of the pusher to required criteria (s. section
above). Information on positioning devices s. from page 36.
Let further products run-in singly in the labeling system to check the adjust-
ment.
Page 54 of 77
32708885 Geset 100
GB

Advertisement

Table of Contents
loading

Table of Contents