Cleaning Of Base Conveyor - Weber Geset 100 Original User Manual

Chapter 9 Maintenance
Step
8
9
10

Cleaning of base conveyor

Residues at base conveyor complicate the lateral belt run. At the bottom side of the base
conveyor, dirt, label rests or small parts may get onto the rollers and tip.
The base conveyor and adjacent assembly parts have to be cleaned regularly and careful-
ly.
Requirements
Labeler is without electrical power.
¥
No transportation of products.
¥
Required equipment:
Alcohol (*21800915) and/or roller solvent (*21800977)
¥
Lint-free cloth (*21800978)
¥
Label remover (*21800771)
¥
* Product recommendation. Can be obtained from the Bluhm Weber Group with the eight-character article number.
Instruction
Please clean the base conveyor as follows.
Step
1
2
Version: 16.07.13
Procedure
Check the distances to other system parts.
Check the oil- and grease lubrication at flange bearings and the drive motor
block.
Oil and lubricate the flange bearings and the drive motor block according to
the respective maintenance instructions.
Procedure
Remove strong sticking adhesive- and label residues with label remover.
Clean carefully track bed, base conveyor and adjacent assembly parts.
Page 66 of 77
32708885 Geset 100
*² Only if system has the appropriate features.
GB