Table of Contents
Advertisement
Chapter 9 Maintenance
Retension of timing belts (Timing belt)
No.
1
2
3
The pick up of the timing belt at the drive roller is arranged by form fit of the pulley. Thus
the required belt tension is much lower than with the base conveyor. The correct tension
is reached when a skipping of the timing belt at the pulley is not possbile anymore. A belt
tension that is too high can result in damages of the deflections, bearings and timing belts.
At optimum belt tension, the belt should be adjusted in center by 90°.
Requirements
No transportation of products.
¥
Labeling station is turned off.
¥
Labeling station was put into operation (see chapter "Installation and initial
¥
startup").
Required tool
Tool: 8 mm Hexagon socket screw wrench
¥
Instruction
Please adjust the web tension at transport timing belt as follows.
Step
1
Version: 16.07.13
Description
CLAMPING SCREW
TRANSPORT TIMING BELT
TOP CONVEYOR
Procedure
Tension the timing belt by means of the clamping screw.
Page 69 of 77
32708885 Geset 100
Fig. 9-2 Tense top conveyor
GB
Advertisement
Table of Contents
