Table of Contents
Advertisement
Chapter 8 Operation
Control element (Pushbutton box)
No.
1
2
3
Turn on labeling operation
The automatic operation is used to label products.
Requirements
Labeling system is turned off.
¥
Material rolls at labeling system loaded and threaded.
¥
Labeling system is connected to power and compressed air.
¥
System was put into operation (see chapter „Installation and initial startup" on
¥
page 38).
Instruction
Please turn on the labeling system for operation as follows.
Step
1
2
3
4
5
Version: 16.07.13
Description
EMERGENCY STOP PUSHBUTTON
RED BUTTON AUTOMATIC OFF
GREEN ILLUMINATED BUTTON AUTOMATIC ON
Procedure
Turn on the main switch.
RISK OF INJURY FROM CRUSHING!
-
Maintain a distance from moving parts
Push the [START] –button at labeler.
Push the [AUTOMATIC ON] –button at control element.
Add the products to the labeling station.
Remove the products from outfeed of labeling system.
Page 56 of 77
32708885 Geset 100
Fig. 8-3: Display- and operator elements
GB
Advertisement
Table of Contents
