Mechanical Error - Weber Geset 100 Original User Manual

Chapter 10 Troubleshooting

Mechanical error

Problem
Label liner tears.
Label placement on
the product is consis-
tently poor.
The desired rate of
application can not be
reached with the labe-
ler.
Machine functions
occur at random with-
out being initiated.
Incomplete label feed.
No label feed possible.
Version: 16.07.13
Possible cause
Label roll is damaged.
Nicks or label cutter-die damage on
liner.
Dents/damages at the side of the
label roll.
The liner width varies significantly.
Adhesive residues in the area of
the peeler bar.
The product is not yet/ not anymore
incorrect labeling position.
Product sensor (or its reflector) are
loose or vibrate.
Changing conveyor speed (e.g.
depending on load)
Label with not suitable adhesive,
insufficient initial adhesion.
Wrong parameterization.
The required rate of application
from the conveyor exceeds the
specifications.
Incorrect configuration parameter
values of the labeler. Excessive
cycle processing time.
Product detector loose or vibrating
or being affected of reflecting light
from product surface.
Loose wiring connections.
Powered rewinder is not switched
off by rewinder dancer arm.
The unwinder brake is not ap-
proved by unwinder dancer arm.
Tamp home sensor is broken or out
of adjustment.
Page 73 of 77
32708885 Geset 100
Solution
Exchange label roll.
Remove adhesive residues and
check the label roll for damages
caused by adhesive residues.
Otherwise exchange roll.
Check sensors of the conveyor
used to determine the product's
stop position.
Check sensors and remount, if
required.
Check the speed and record.
Contact supplier of conveying
system.
Change label quality.
Check time- and delay settings
of the responsible configuration
parameters (blow-, extension-
...)
Check conveyor speed and the
product gap. Reduce conveyor
speed if possible.
Check the delay times. Inquire
Service Technician at the Hot-
line (s. page 8).
Check the adjustments of the
sensors and inquire if needed a
Service-Technician at the Ser-
vice-Hotline (s. page 8).
Check all connections at la-
beler.
Control the function of the
dancer arm. If the liner tenses,
the Rewinder has to stop.
Control the function of the
dancer arm. If the label web
becomes more tense, the label
roll has to be unwinded easily.
Replace or adjust sensors as
needed or inquire Service
Technician at the Service-
Hotline (s. page 8).
GB