Table of Contents
Advertisement
Chapter 2 Safety regulations
Following assembly groups may point out an entanglement or a crushing hazard f.l.t.r.:
Top conveyor,
•
Wrapping unit,
•
Base conveyor
•
Labeler,
•
Guidances.
•
Possible injuries that may be caused by the assembly groups of the labeler, are normally
reversible.
Safety instructions
Version: 16.07.13
Hazard from direct or indirect contact with voltage-
conducting parts.
DANGER TO LIFE!
When individuals touch parts that conduct electricity arising from
malfunctions.
- Only electricians may work on the switch cabinet and electri-
cal equipment.
- Regularly check the electrical equipment of the labeling sys-
tem. Immediately take care of loose connections and dam-
aged cables.
- Always keep the switch cabinet locked.
- Before working on electrical equipment, switch the miniature
circuit breaker to "0" position and secure it against being ac-
cidentally turned on. If possible, disconnect the power.
Hazard from easily flammable label material.
FIRE HAZARD!
The ribbon and labels are easily flammable. Potential injury from
fire and smoke.
- Keep away from sources of ignition and open fire.
Hazard from actively controlled movements.
DANGER OF BEING PULLED IN!
Rotating elements at the labeling station, like transport- side- or
top- conveyor, chain alignment, rewinder, driving- and transport
rollers ... are driven by a motor.
̶ Do not grip in, at or between the moving parts.
̶ Wear only work clothes that fit snugly, tear easily, have tight-
fitting sleeves and no projecting parts
̶ Do not wear jewelry, wristlets, watches or similar.
Page 17 of 77
32708885 Geset 100
GB
Advertisement
Table of Contents
