Table of Contents
Advertisement
Chapter 7 Adjustment and initial operation
Requirements
Power supply is turned off.
¥
One or more sample products.
¥
No transportation of products.
¥
Instruction
Please adjust the top conveyor as follows.
Step
1
2
3
4
5
6
Information on adjustment of top conveyor without spindle adjustment
The top conveyor provides at beginning and end a diagonal infeed or outfeed. In order to
adjust the top conveyor height to the product, please position the product in the center ar-
ea of the slopes (Fig. 7-6: Pos. 5). The right top conveyor height is achieved if the product
is positioned tightly between both conveyor belts (Fig. 7-6: Pos. 6) and it does not deform
in doing so.
Requirements
Power supply is turned off.
¥
One or more sample products.
¥
No transportation of products.
¥
Instruction
Please adjust the top conveyor as follows.
Step
1
2
3
4
Version: 16.07.13
Procedure
Loosen the interlock (clamping lever Pos. 3 Fig. 7-6).
Open the top conveyor with the crank (Fig. 7-6: Pos. 1), until a product can
be placed between top- and base conveyor.
Adjust the top conveyor to the required criteria (s. section above).
Tighten again the interlock (clamping lever Pos. 3 Fig. 7-6).
Remove the product.
Arrange several sample labelings to check the adjustments.
Procedure
Crushing hazard!
After loosening the clamping device, the top conveyor will lower in direction
to the base conveyor.
-
Maintain a distance from top- and main conveyor.
Support the top conveyor with a suitable device to avoid a lowering of the
top conveyor to the base conveyor.
Loosen the interlock (clamping lever Pos. 3 Fig. 7-6).
Lift the top conveyor until one product can be placed between top- and base
conveyor.
Remove device from pos. 1.
Page 43 of 77
32708885 Geset 100
GB
Advertisement
Table of Contents
