Table of Contents
Advertisement
Chapter 7 Adjustment and initial operation
Information on adjustment of peeler plate (side labeling)
The peeler plate has to be positioned in a distance of appr. 1-3 mm. to the product by the
positioning device of the labeler (no product touching!). The peeler plate should be located
in a blade angle of 15° - 30° to the product.
No.
1
2
3
4
Requirements
Side guidances (s. page 41) and chain alignment (page 44) are correctly adjust-
¥
ed.
Labeling system is turned on and ready for operation.
¥
One or more sample products.
¥
No transportation of products.
¥
Please adjust the peeler plate to the product as follows
Step
1
2
3
Version: 16.07.13
Description
BASE CONVEYOR
PEELER PLATE
PRODUCT
LABEL
Procedure
Place one product at the infeed passage of the system.
Hazards from actively controlled movements.
Maintain a distance from moving parts.
Start briefly the base conveyor and stop it when the product is in the area of
the peeler plate.
Please adjust the peeler plate's height (Info s. section above). Use therefore
the positioning device of the respective labeler (s. from page 36).
Page 49 of 77
32708885 Geset 100
Fig. 7-11: Adjust peeler plates
GB
Advertisement
Table of Contents
