Table of Contents
Advertisement
Chapter 6 Installation and initial startup
6. Installation and initial startup
Safety instructions
Installation
Continuous operation with minimal wear and downtime can only be ensured when the
system is installed properly. Fine adjustments to the conditions of use are essential when
installing the system. These fine adjustmetns are adapted to the surrounding conditions.
To make these fine adjustments, detailed professional knowledge is necessary that arises
from experience with labeling systems.
This required professional knowledge cannot be completely communicated by the operat-
ing instructions; therefore a Technician from the Bluhm Weber Group needs to perform
the installation or accept the labeling system in a final inspection. The warranty does not
cover damage or consequential damage arising from improper installation lacking the
necessary fine adjustments.
Requirements at the installation site
An enclosed and clean room.
¥
Flat, solid base.
¥
Any unevenness may not exceed 5 mm when stands from the Bluhm Weber
¥
Group are used.
Sufficient bearing capacity: 1,500 kg/m².
¥
Low vibration environment.
¥
Sufficient lighting: 500 Lx.
¥
No direct exposure to sunlight or a radiator.
¥
The machine may not be operated within electrostatic or magnetic fields. This
¥
can cause the controls to malfunction.
A proper energy supply (electricity) according to the chapter, "Specifications" on
¥
page 24.
Version: 16.07.13
Danger to life from actively controlled movements.
RISK OF INJURY FROM CRUSHING!
The movements of the labeling system are motor-driven by an
automatic controller in automatic operation.
- Maintain a distance from moving parts.
Danger of being pulled in by rotating elements.
DANGER OF BEING PULLED IN!
Rotating elements at the labeling machine, backing rewinder, label
feed, *²conveyor belt and *²top conveyor are driven by a motor.
- Do not grip in, at or between the moving parts.
Page 32 of 77
32708885 Geset 100
GB
Advertisement
Table of Contents
