Table of Contents
Advertisement
Chapter 1 General information
Explanation of the terms used
Term
3-Roll System
Actuator
Air assist tube
Air assist
Air Blast)
Application cycle
Application mode
Automatic mode
Base conveyor
Blow-on
Conveying system
Conveyor
CS
Dancer arm
Default
Default
Gimbal adjustment
HMI
Home position
Hotline
Version: 16.07.13
Explanation
Is used for labeling around of round products.
Drive for rotating or linear movements. Normally pneumatic
(cylinder) or electromagnetic (motors).
The air assist tube conducts the supporting air through one
or more holes to the bottom of the label. It is attached next
to the peeler bar and can be adjusted.
A jet of air that, when the label is being fed, presses the
label against the bottom of the tamp until it is held by the
vacuum.
Air that blows on the label through holes in the tamp pad at
the time of labeling (through house nozzles when there is a
blow box) so that the label is placed on the product without
being touched.
Complete operating sequence of the labeling system (such
as printing the label, peeling it off, transferring it to the ap-
plicator and labeling the product).
Depending on labeler's equipment, different application
modes can be applied. See explanations: Tamp on, tamp
blow, blow on and wipe on.
See labeling operation
See also "conveying system". The base conveyor trans-
ports the products that should be labeled.
Contact-less application mode in which the tamp receives
the printed label by a vacuum and blows it onto the product
without the tamp moving.
The unit consisting of the conveyor belt and its control
Belt for conveying the product
Abbreviation for conveying system (see above)
The arm that holds the label liner taught by spring tension.
All basis settings for the system after it is made that can
differ from the status after the system is started up. The
software parameters can be returned to the defaults by be-
ing reset, and any changed values are lost.
See factory-setting.
The gimbal adjustment is used to align the longitudinal and
lateral inclination of the labeling system and thus the peeler
bar to product. The peeler blade has to be aligned parallel
to product.
Abbreviation for Human-Machine-Interface, input unit for a
labeling system or a controller of components.
Basic position of the tamp at the peeler bar
Customer support for a fast diagnosis by phone.
Page 9 of 77
32708885 Geset 100
GB
Advertisement
Table of Contents
