Adjust Base Conveyor - Weber Geset 100 Original User Manual

Chapter 7 Adjustment and initial operation

Adjust base conveyor

The base conveyor transports the product to be labeled from infeed passage to labeler
and from labeler to outfeed passage. .
Information on adjustment of base conveyor's height
The height of the base conveyor has to be adapted to the customer-specific conveyor sys-
tem or to the ergonomic requirements of the operator personnel accordingly.
The base conveyor (Fig. 7-4: Pos. 1) is installed fix. The height of the base conveyor can
be adjusted by the threads at the rubber feet (Fig. 7-4: Pos. 4) of the switch cabinet.
No.
1
2
3
4
Requirements
Power supply is turned off.
¥
No transportation of products.
¥
Required equipment
Screw wrench (for rubber feet adjustment)
¥
Air level
¥
Instruction
Please adjust the height of the base conveyor as follows.
Step
1
2
3
Version: 16.07.13
Description
BASE CONVEYOR
DRIVE MOTOR
SWITCH CABINET
RUBBER FEET
Procedure
Loosen the counternuts of the rubber feet.
Adjust the height of the base conveyor to the required criteria (s. section
above).
Tighten again the counternuts.
Page 40 of 77
32708885 Geset 100
Fig. 7-4: Base conveyor and switch cabinet
GB