Table of Contents
Advertisement
Chapter 9 Maintenance
Adjust belt tension
The manufacturer's adjustment of the base conveyor does normally not require any adap-
tion. If tension or the base conveyor' s run have to be readjusted, it has to be arranged by
experts only.
Requirements
Labeler is without electrical power.
¥
No transportation of products.
¥
Instruction
Please adjust the belt tension as follows.
Step
1
2
3
4
Version: 16.07.13
Procedure
Apply two markings with a highest possible distance (e.g. 500 mm) at the
upside of the base conveyor.
Calculate the required lengthening of the base conveyor. (e. g. lengthening:
500 mm +0,5 % = 2,5 mm).
Tense the base conveyor with both clamping nuts until the distance between
the markings has increased by the calculated value (e. g. 500 mm+2,5 mm =
502,5 mm).
Observe that the tension pulley is tensed parallel.
Fix this adjustment with both counternuts.
Page 67 of 77
32708885 Geset 100
GB
Advertisement
Table of Contents
