Table of Contents
Advertisement
Chapter 7 Adjustment and initial operation
Clamp lever for adjustment or interlock
Spindle adjustments and digital counter
Depending on version, a system provides spindle adjustments with different inclinations. I.
e. at a crank rotation, the spindle slide covers a distance of resp. 2 or 4 mm
No.
1
2
3
4
Record of adjustment values
Adjustments with scales or digital counters simplify the position determination and enable
thus repeatable adjustment for each product charge.
For labeling stations with scales or digital counters, we recommend to maintain a list with
„values per product". All relevant settings should be numbered to ease the assignment of
the values.
All relevant adjustments are numbered (s. Pos 4, Fig. 7-3), to ease the alignment of
documented values. They have then only be adjusted at product change only at the
respective adjustments.
For labeling stations without scales or counters, there can maybe arranged markings at
the adjustments if applicable.
Version: 16.07.13
Fig. 7-2: Move clamp lever
Description
CLAMP LEVER
CRANK
DIGITAL-COUNTER [mm], 1/10 [mm]
NUMBERING OF THE ADJUSTMENT
Page 37 of 77
The most simple kind of adjustment is the clam-
ping piece with clamp lever (s. Fig. 7-1, Pos. 10).
If the clamp lever can not be rotated by 360 ° due
to shortage of space, it can be easily moved by
being pulled out (s. Fig. 7-2).
Clamp levers are also used for interlock of spindle
slides (s. Fig. 7-1, Pos. 3). They will always have
to be loosened before adjustment and then they
have to be tightened again.
Fig. 7-3: Spindle adjustment with digital counter
32708885 Geset 100
GB
Advertisement
Table of Contents
