Table of Contents
Advertisement
Chapter 8 Operation
Control element
The control elements are located at the switch cabinet .
No. Term
1
2
3
Turn on labeling operation
The automatic operation is used to label products.
Requirements
¥
Labeling system is turned off.
¥
Material rolls at labeling system loaded and threaded.
¥
Labeling system is connected to power.
¥
System was put into operation (see chapter „Installation and initial startup" on
page 29).
Instruction
Please turn on the labeling system for operation as follows.
Step
1
3
4
5
Version: 15.01.14
Main switch
White illuminated button
[On]
Red button [Off]
Procedure
Turn on the main switch.
Risk of injury from crushing! Hazards from actively controlled movements.
Keep away from moving parts.
Push the [ON]-button at the switch cabinet to start automatic labeling
operation.
Add the products to the labeling system.
Remove the products from outfeed of the labeling system or *²turning plate.
page 43 of 59
Descritption
Switches on and off the labeler.
Switches on the base conveyor.
Switches off the base conveyor.
40002674 BTA Geset 117
Fig. 8-3: Control elements
GB
Advertisement
Table of Contents
