Broadcast Suppression Screen - Cabletron Systems 2E48-27R User Manual

Chapter 5: Local Management
5.18

BROADCAST SUPPRESSION SCREEN

The Broadcast Suppression screen,
desired limit of receive broadcast frames that are switched out to the other
ports.
The Broadcast Suppression screen may not be available if the
NOTE
operational mode of the device is set to SECURE FAST VLAN.
Refer to the Release Notes to see which operational modes
support the Broadcast Suppression screen.
Setting the Operational
device to operate in this mode.
Broadcast frames received above the threshold setting are
dropped.
To access the Broadcast Suppression screen from the Device Specific
Configuration Menu screen, use the arrow keys to highlight the
BROADCAST SUPPRESSION menu item and press ENTER. The
Broadcast Suppression screen displays.
Event Message Line
Device Type: 2E48-27R
PORT # Total RX
1 12345678910
2 12345678910
3 12345678910
4 12345678910
5 12345678910
6 12345678910
7 12345678910
8 12345678910
9 12345678910
10 12345678910
11 12345678910
12 12345678910
SAVE
Figure 5-26 Broadcast Suppression Screen
5-64
Figure
Mode, describes how to configure the
2E48-27R LOCAL MANAGEMENT
Broadcast Suppression
Peak Rate Time Since Peak
150000 999:23:59
150000 999:23:59
150000 999:23:59
150000 999:23:59
150000 999:23:59
150000 999:23:59
150000 999:23:59
150000 999:23:59
150000 999:23:59
150000 999:23:59
150000 999:23:59
150000 999:23:59
EXIT
5-26, allows the user to set a
Firmware Revision:
BOOTPROM Revision: XX.XX.XX
Threshold
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
[13-24]
2E48-27R/2E49-27R User's Guide
Section 5.7.9,
XX.XX.XX
Reset Peak
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
RETURN
RETURN
23141-56