Accessing Local Management - Cabletron Systems 2E48-27R User Manual

Chapter 5: Local Management
5.4

ACCESSING LOCAL MANAGEMENT

Access to Local Management is controlled through the Local
Management Password screen shown in
connection is made to the 2E4X-27R the Local Management Password
screen displays. Before continuing, the user must enter a password
(community name) which is compared to the previously stored
passwords. The level of access allowed the user depends on the password.
To set or change passwords, refer to
describe the procedure to access Local Management.
1. Turn on the terminal. Press ENTER (this may take up to four times,
because the COM port of the 2E4X-27R auto-senses the baud rate of
the terminal) until the 2E4X-27R Local Management Password screen
displays.
Event Message Line
Figure 5-3 The 2E4X-27R Local Management Password Screen
2. Enter the Password and press ENTER. The default super-user access
password is "public" or press ENTER.
5-8
Section
2E48-27R LOCAL MANAGEMENT
CABLETRON Systems, Incorporated
P.O.Box 5005
Rochester, NH 03866-5005 USA
(603) 332-9400
(c) Copyright CABLETRON Systems, Inc, 1997
Device Serial Number:
Device Hardware Revision:
Device Firmware Revision:
Device BOOTPROM Revision:
Enter Password:
Figure 5-3. Whenever a
5.8. The following steps
XXXXXXXXX
XX
X.XX.XX
X.XX.XX
2E48-27R/2E49-27R User's Guide
23141-12