Ethernet Full Duplex Configuration Screen - Cabletron Systems 2E48-27R User Manual

Chapter 5: Local Management
5.11 ETHERNET FULL DUPLEX CONFIGURATION
SCREEN
The Ethernet Full Duplex Configuration screen,
user to set ports 1 through 24, individually or all at once, to either
Standard Ethernet or Full Duplex operation, and monitor each port to see
whether or not it is enabled and linked to another 10BASE-F device.
Refer to Section 5.15
To access the Ethernet Full Duplex Configuration screen from the Device
Configuration Menu screen, use the arrow keys to highlight the
ETHERNET FULL DUPLEX CONFIGURATION menu item and
press ENTER. The Ethernet Full Duplex Configuration screen displays.
Event Message Line
Device Type: 2E48-27R
OPERATION MODE
PORT #
[STANDARD ENET]
1
[STANDARD ENET]
2
[STANDARD ENET]
3
[STANDARD ENET]
4
[STANDARD ENET]
5
[STANDARD ENET]
6
[STANDARD ENET]
7
[STANDARD ENET]
8
[STANDARD ENET]
9
[STANDARD ENET]
10
[STANDARD ENET]
11
[STANDARD ENET]
12
SAVE SET ALL PORTS: [FULL]
Figure 5-19 Ethernet Full Duplex Configuration Screen
This section explains each field of the Full Duplex Configuration screen.
PORT # (Read-only)
Identifies the number of the port.
5-42
to set the Operation Mode for ports 25 and 26.
2E48-27R LOCAL MANAGEMENT
Ethernet Full Duplex Configuration
LINK STATUS
Link
Link
Link
No Link
Link
Link
Link
Link
Link
Link
Link
Link
EXIT
Figure
Firmware Revision:
BOOTPROM Revision: XX.XX.XX
PORT STATUS
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
[13-24]
2E48-27R/2E49-27R User's Guide
5-19, allows the
XX.XX.XX
RETURN
RETURN
23141-21