Appendix Coptional Installations And Mode Switch Bank Settings; Required Tools; C.1 Required Tools; Removing The Chassis Cover - Cabletron Systems 2E48-27R User Manual

Appendix C: Optional Installations and Mode Switch Bank Settings
C.1

REQUIRED TOOLS

You need the following tools to perform the procedures provided in this
appendix:
• Antistatic wrist strap
• Phillips screwdriver
C.2

REMOVING THE CHASSIS COVER

This section describes how to remove the 2E4X-27R chassis cover.
DO NOT REMOVE THE COVER FROM THE 2E4X-27R
WHILE POWER IS APPLIED TO THE UNIT. HAZARDOUS
VOLTAGES ARE PRESENT AND COULD CAUSE PERSONAL
INJURY AND/OR DAMAGE THE UNIT.
DO NOT POWER UP THE 2E4X-27R AGAIN UNTIL THE
COVER AND SCREWS ARE IN PLACE.
DECKEL VON DAS 2E4X-27R NICHT ABZIEHEN UNTER
SPANNUNG. GEFAHR FÜR DAS PERSONNAL UND/ODER
DAS GERÄT WEGEN GEFÄHRLICHE SPANNUNGEN
ENSTEHT.
2E4X-27R NICHEINSCHALTEN SO LANG DER DECKEL
UND SCHRAUBEN NICHT EINGEBAUT SIND.
NO DEBE DE REMOVER LA TAPA DURENTE QUE ESTE
CONELTADO A LA CORRIENTE, UNA DESCARGA
ELECTRICA LE PUEDE CAUSAR Y PROBOCARLE DA
AL IGUAL QUE AL APARATO.
NO ENCHUFE A LA CORRIENTE HASTA QUE LA TAPA Y
LOS TORNILLOS ESTEN EN SU LUGAR.
C-2 2E48-27R/2E49-27R User's Guide
Ñ OS,