Using The Wizard To Configure Your Iscsi Storage Appliance - Adaptec 5325302057 User Manual

Using the Wizard to Configure Your iSCSI Storage
Appliance
The Setup wizard runs if the iSCSI Storage Appliance is in factory default state
when the CLI is started. (You can also run the Setup wizard by typing
Setup wizard prompts you to enter the information required to connect the iSCSI
Storage Appliance to a local network. In addition to typing in the values (the
answers to the questions), you can also use the three commands in this table.
Command
*abort
*back
Help
If a question has a predefined or default answer, the answer appears in square
brackets .
[ ]
Some values take an arbitrary string, in which case you can't use the
commands. In those circumstances, enclose the answer in double-quotes " " so that
the answer will be accepted even if it is the same as a command.
To configure the iSCSI Storage Appliance:
Power on the iSCSI Storage Appliance.
1
The Command Line Interface (CLI) Setup wizard opens.

Using the Wizard to Configure Your iSCSI Storage Appliance

Function
Quit the Setup wizard without changing anything
Go to previous question
Describe the current options
setup
or
*back
Appendix B Using the CLI
.) The
*abort
179