Appendix B Using The Cli; Accessing The Cli - Adaptec 5325302057 User Manual

U s i n g t h e C L I
The Command Line Interface (CLI) software is a terminal-based command line
interface that allows you to monitor and manage the iSCSI Storage Appliance. You
can use the CLI to create and manage iSCSI targets that will appear as local disk
storage on your server. You can use the CLI's event logging features to monitor the
entire system.
This appendix introduces the CLI and provides instructions for using the CLI to
configure the settings on your iSCSI Storage Appliance.

Accessing the CLI

You can access the CLI two ways. Each method presents the CLI automatically:
• Attach a VT100 terminal emulation utility (for example, hyperterminal) to the
serial port of the iSCSI Storage Appliance.
Use these terminal emulation program settings to access the CLI:
• Null Modem Cable
• Baud Rate: 115,200
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: Off
Flow control must be set to
Note
hang.
• Connect to the iSCSI Storage Appliance through a Telnet session (once the initial
network values have been set.)
Telnet to the IP address that is assigned to the management port on the iSCSI
Storage Appliance.
The default administrator password is
Note
. Otherwise, the system will appear to
Off
.
admin
Snap Server 700i Series User's Guide
Appendix B
177