Adaptec 5325302057 User Manual page 43

Under Network settings, enter the values you prepared in "Before You Begin" on
2
page 34.
Enter a name for the iSCSI Storage Appliance and the network domain to which
the iSCSI Storage Appliance belongs.
Enter a gateway name or IP address, or accept the default gateway.
Enter IP addresses for up to three domain name servers, if required.
(Optional) Under CLI settings, change the Administrator and Operator passwords
3
from their defaults. (By default, both passwords are 'admin'.)
Click , then set values for each Ethernet port on your iSCSI Storage
Next
4
Appliance, using the tabs at the top of the window to ensure that all ports are
configured. Use static IP addresses for each port, and ensure that DHCP is
deselected.
Click tabs to
view other
ports
Deselect
DHCP
By default, Ethernet Port 0 is the management port and is used by the
Note
Management Service to communicate with your iSCSI Storage Appliances; it is
also an iSCSI port. You can configure Ethernet Port 0 as a management port only
by selecting that option in the Port Type drop-down menu.
Click . By default, the current date and time is used for the iSCSI Storage
Next
5
Appliance. You can choose to manually set the date and time values, if required.
The Adaptec OnTarget operating system does not automatically adjust the
Note
time setting on your iSCSI Storage Appliance to accommodate Daylight Saving
Time. However, the appliance uses the time setting for event timestamps only;
the appliance time setting is not used for job schedules or other functions.
Click , confirm the settings for this iSCSI Storage Appliance, then click
Next
6
Chapter 4 Setting Up Your iSCSI Storage Appliance and IP SAN
Step 2: Configuring the iSCSI Storage Appliance
.
Apply
37