Adaptec 5325302057 User Manual page 122

Using Status and Drive Light Behavior to Monitor Components
The LEDs operate as described in the following tables:
Power LED
Solid green
Off
System LED
Blinks green 2 times
per second
Blinks green 3 times
per second
Solid or blinking
amber at boot time
Blinking amber
during normal
operation
Solid amber
LAN 1 and LAN 2 LEDs (ETH0 and ETH1)
Solid green
Off
LAN 3 and LAN 4 LEDs (ETH2 and ETH3 on NIC card on rear of server)
Activity LED
10/100/1000T LED
Unit ID (UID) Front
and Back LEDs
Blue
Off
116 Snap Server 700i Series User's Guide
The server is powered on.
The server is powered off.
The server is booting up.
The server is shutting down.
A problem was detected. The server will not boot.
A thermal problem was detected.
Other problem was detected.
The server is active and connected to the network.
The port is disconnected or the Ethernet cable is not
connected or linked to an active switch.
Solid green The server is active and connected to the network.
Green flashing Indicates data activity
Off The port is disconnected or the Ethernet cable is
not connected or linked to an active switch.
Solid yellow Indicates speed at 1000T
Amber flashing The adapter is being identified.
Unit ID is on and identifies the unit (front and back).
Unit ID has not been turned on.